Skip to product information
About This Product
Amana® PHWT-A200 Programmable Wired Thermostat
SKU: PHWT-A200
About This Product
- A variety of wired thermostats may be used with the Amana brand PTAC.
- All thermostats offered can be connected to the PTAC through a low-voltage connection.
- The Amana brand DigiSmart™ PTAC also offers a wireless remote thermostat.
- Any thermostats other than those listed below or the DigiSmart thermostat must be submitted to Goodman for approval prior to use.
Specs & Details
SPECIFICATIONS
| Model | PHWT-A200 |
| Type | Programmable Electronic Thermostat |
| Input Voltage | 19 to 30 VAC |
| Output Rating | Max. 1.5A per terminal (3A total) |
| Temperature Control Range | 45°F to 90°F (7°C to 32°C) |
| Temperature Accuracy | ± 1°F (± 0.5°C) |
| Temperature Scale | °F or °C |
| Temperature Calibration | -5°F to +5°F (-3°C to +3°C) |
| Mounting | Wall mount, about 5 ft above floor (on an inside wall) |
WIRE TERMINALS
| C | 24 VAC Common |
| R | 24 VAC Hot |
| Y | Cooling Signal |
| W1 | 1st Stage Heating Signal |
| W2 | 2nd Stage or Auxiliary Heating Signal |
| GL | Fan LOW Speed |
| GH | Fan HIGH Speed |
| B/O | Reversing Valve |
COMPATIBILITY
| Conventional PTAC (Amana PTC) | Up to 1 Heat / 1 Cool, with or without electric heat |
| Heat Pump PTAC (Amana PTH & HEH) | Up to 2 Heat / 1 Cool, with or without electric heat |
| Single-Speed Fan Units | Supported (use GL terminal, High Fan set to OFF) |
INSTALLER SETTINGS
| Available Modes | Heat/Cool/Auto Heat/Cool Heat Only Cool Only |
| Max. Heat Set Point | 60°F to 90°F (default 80°F) |
| Min. Cool Set Point | 60°F to 80°F (default 65°F) |
| System Type | Heat Pump or Conventional |
| HP Valve Type | B (on in Heat) or O (on in Cool) |
| Auto Dead-Band | 2.0°F, 3.0°F, 4.0°F, 5.0°F |
| Swing / Temp. Differential | ±0.25°F, ±0.50°F, ±1.00°F, ±2.25°F |
| Aux. Stage Offset (Heat Pump) | Off, 1.0°F to 5.0°F |
| High Fan | Available or Disabled |
| Programming | Manual or Programmable |
| Clock Format | 12 hr (AM/PM) or 24 hr |
| Periods per Day | 4, 2 or 1 |
| Default Heat Set Temp | 70°F (21°C) |
| Default Cool Set Temp | 74°F (23°C) |
| Compressor Protection Bypass | Installer test mode (auto-resets after 5 min) |
| Factory Reset | Yes |
DEFAULT PROGRAM SCHEDULE (4-PERIOD)
| Morning – 6:00 AM | Heat 70°F / Cool 78°F |
| Day – 8:00 AM | Heat 62°F / Cool 82°F |
| Evening – 6:00 PM | Heat 70°F / Cool 78°F |
| Night – 10:00 PM | Heat 62°F / Cool 75°F |